Launch control
-
- Posts: 192
- Joined: Wed Aug 22, 2007 12:41 am
Launch control
By selecting the "always on" and datalog it from the S200 to update, will the launch control work w/o a switch? is it the same as the S300 when you select "always on" Thank you.
-
- Posts: 192
- Joined: Wed Aug 22, 2007 12:41 am
Never mind on this one I figured this one out already.
My other question is, how come when I set the launch limiter to 3500rpm and try to rev the motor and the tach showing 4500rpm? why is this. It's 1000rpm off.
My tach is accurate because I tried it on me s300 and set the launch limiter to 3500rpm and it is accurate and shows 3500rpm dead on.
My other question is, how come when I set the launch limiter to 3500rpm and try to rev the motor and the tach showing 4500rpm? why is this. It's 1000rpm off.
My tach is accurate because I tried it on me s300 and set the launch limiter to 3500rpm and it is accurate and shows 3500rpm dead on.
i had this problem too after i update the software to 1.1 but mine was like 2500 offV-Spec race development wrote:Never mind on this one I figured this one out already.
My other question is, how come when I set the launch limiter to 3500rpm and try to rev the motor and the tach showing 4500rpm? why is this. It's 1000rpm off.
My tach is accurate because I tried it on me s300 and set the launch limiter to 3500rpm and it is accurate and shows 3500rpm dead on.
also u should check your a/f after u burn the chip its different from when u tune on ur romulator...........
-somethings up before i updated it was all fine.......................