Boost option, boost cut problem

ROM Editor 4 tuning software questions and answers.
Post Reply
maxhohenlohe
Posts: 7
Joined: Tue May 02, 2006 11:12 am
Contact:

Boost option, boost cut problem

Post by maxhohenlohe » Fri Nov 08, 2013 9:34 am

I just got the boost option and 3 step enabled a few days ago.
I started a fresh map, added boost tables, etc and i get a boost cut at 1psi with a quick cel blink.
I set boost cut to 0kpa and shut off boost cut if check engine light, for testing and i still get the boost cut.
Crome works fine...

Any suggestions?

User avatar
Spunkster
Site Admin
Posts: 17864
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Boost option, boost cut problem

Post by Spunkster » Mon Nov 11, 2013 10:51 am

What is the serial number of the s200?

maxhohenlohe
Posts: 7
Joined: Tue May 02, 2006 11:12 am
Contact:

Re: Boost option, boost cut problem

Post by maxhohenlohe » Mon Nov 11, 2013 2:36 pm

s200-3250 (Came with Datalogging)
Romeditor 4# #0270 (Purchased with Boost and 3 Step)

I havnt had a problem with any NA cars as of yet, and generally for boost i suggest customers purchase an s300 from me so i just noticed this going on recently.

I wish s100 had injector dead times, but id asume that wont be an option since s200 is obsolete, but either way im not sure whats causing this issue.

And i am a Hondata Dealer.

User avatar
Spunkster
Site Admin
Posts: 17864
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Boost option, boost cut problem

Post by Spunkster » Tue Nov 12, 2013 10:51 am

You will need to post your calibration as well as a datalog showing the problem.

Post Reply