Using preloaded map but modifying secondary 02

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
xplizitremix
Posts: 5
Joined: Sat Apr 26, 2008 10:18 am

Using preloaded map but modifying secondary 02

Post by xplizitremix »

I want to run a Toda map on my Flashpro but I want to eliminate the secondary 02 sensor so i can remove it completely from my exhaust system.

Can anyone guide me through the steps to do that?

I have an 06 + S2000
Looking to run the Toda reflash but just eliminating secondary 02 sensor as I find its useless on my J's Racing 70RR exhaust

User avatar
Spunkster
Site Admin
Posts: 18128
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Using preloaded map but modifying secondary 02

Post by Spunkster »

In the calibration under closed loop, just disable the secondary o2 sensor and upload the calibration.

xplizitremix
Posts: 5
Joined: Sat Apr 26, 2008 10:18 am

Re: Using preloaded map but modifying secondary 02

Post by xplizitremix »

^ Thanks for the reply

So i would have to open the toda map first, then in calibrations disable it then save it first? or do i just load what i just modified ontop flashpro and i Should be good to go?

I thought i did this the first time but my car threw a CEL after i removed my secondary 02 sensor from the car. (Disconnected it completely from the plug)

User avatar
Spunkster
Site Admin
Posts: 18128
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Using preloaded map but modifying secondary 02

Post by Spunkster »

If you are having a problem you must post the calibration and a datalog showing the problem as well as a detailed description of the problem. Also a list of what has been done to the car.

Post Reply