Need calibration for stock K24, 8.8:1 CR forged pistons

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
core58
Posts: 20
Joined: Mon Jan 09, 2012 2:35 pm

Need calibration for stock K24, 8.8:1 CR forged pistons

Post by core58 » Wed Sep 12, 2012 2:06 pm

hey fellows!

i've had my engine rebuilt (forged pistons + rods) and looking to install the turbo stuff now. Until that i need some calibration that will be good for this stock low compression ratio engine, the base TSX 04 cal gives awful AFR at full and even part throttle, the air-fuel mixture is lean (> 17).

Maybe someone has such a calibration? Many thanks in advance!!
p.s. engine is full stock K24A2, stock intake + exhaust, only forged internals, 8.8:1 CR.

mabo
Posts: 64
Joined: Sun Mar 18, 2012 2:21 pm

Re: Need calibration for stock K24, 8.8:1 CR forged pistons

Post by mabo » Thu Sep 13, 2012 1:55 pm

I pissed my pants ) You really think every second bro here have a cal for stock non boosted k24 with 8.8 CR ? Dude, pull this post out b4 guys decided that something wrong happened with your brain.

core58
Posts: 20
Joined: Mon Jan 09, 2012 2:35 pm

Re: Need calibration for stock K24, 8.8:1 CR forged pistons

Post by core58 » Thu Sep 13, 2012 2:48 pm

mabo wrote:I pissed my pants )
Fine, dude.
It's about time for you to leave this thread and run to the bathroom

tomzauto
Posts: 40
Joined: Fri Nov 20, 2009 5:21 pm
Location: Lebanon, PA

Re: Need calibration for stock K24, 8.8:1 CR forged pistons

Post by tomzauto » Thu Sep 20, 2012 4:00 am

i can def help you out, check out my site

tomzautotuning.com or email tomzauto@yahoo.com

Post Reply