Map fuel tables and disable maf

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
Hybrid_Hatch
Posts: 31
Joined: Sun Oct 06, 2002 1:46 am
Contact:

Map fuel tables and disable maf

Post by Hybrid_Hatch » Wed Oct 31, 2012 8:30 pm

hello.

If I run a hybrid afm calibration with map fuel tables enabled can I disable the afm? I am currently running a rsx iat and have deleted the afm all together. I see the "enable maf" in the software, can I just uncheck it? I have the car fully tuned but would like my fuel gauge to act normal and get my oil change minder back, can I just copy/paste my ignition and fuel values from my current tuned map calibration over to the afm calibration with all the other fuel related values and be good to go?

User avatar
Hondata
Site Admin
Posts: 8818
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Map fuel tables and disable AFM

Post by Hondata » Thu Nov 01, 2012 9:19 am

Without know what car & calibration this, I can't answer the question.
Hondata

User avatar
Spunkster
Site Admin
Posts: 18088
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Map fuel tables and disable AFM

Post by Spunkster » Thu Nov 01, 2012 9:38 am

If you are using an AFM calibration then the oil life should still be working.

Hybrid_Hatch
Posts: 31
Joined: Sun Oct 06, 2002 1:46 am
Contact:

Re: Map fuel tables and disable AFM

Post by Hybrid_Hatch » Thu Nov 01, 2012 5:45 pm

opps, my bad.

Car is a 08 civic si and I am currently on a street and dyno tuned Map only calibration, I street tuned the car for drivablity then put it on a dyno for WOT tuning.

what I want to do is transfer all of my values (fuel/ ignition/ over run/ cold start/ ect) over to a "new" AFM calibration and disable the AFM as its no longer installed on the car/engine.

Hybrid_Hatch
Posts: 31
Joined: Sun Oct 06, 2002 1:46 am
Contact:

Re: Map fuel tables and disable AFM

Post by Hybrid_Hatch » Thu Nov 01, 2012 9:24 pm

ok, so I tried it tonight...

I copied all my values over to a new afm cal, I did the fuel, ignition, vtc, over run, cold start, throttle, basically everything, took the car for a few spins while data logging and the car felt weaker, the a/f was the same weather using a afm or map cal and the ignition was the same but the car just didnt not feel anywhere hear as perky and almost stock feeling, I re loaded the Map cal and the car came back to life, so either I did something wrong or a map based cal is what the car wants.

User avatar
Hondata
Site Admin
Posts: 8818
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Map fuel tables and disable AFM

Post by Hondata » Fri Nov 02, 2012 1:41 pm

The fuel tables are different between the race and normal calibrations.

Yes, you can remove the AFM and replace with an IAT.
Hondata

Post Reply