Unable to change any filters for a tune.

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
Posts: 1
Joined: Tue Feb 28, 2017 7:59 pm

Unable to change any filters for a tune.

Post by bjg0493 »

Hello all,
New to the forum. I am currently unable to change any parameter data, as far as mods, on the new calibration setup. I have not used my flashpro for 5 months due to no other modifications. I go to new calibration with the module connected to my laptop, opens up with the new calibrations tab and i have the correct vehicle selected. Where the filters tab is, I click it to display supporting modifications and nothing shows up. I am also unable to perform any function (ie. revert to stock, change tune....etc). I have also ensured that the most current software was up to date ( Any input would be helpful. Thanks guys.
Flashpro.bmp (3 MiB) Viewed 862 times

User avatar
Site Admin
Posts: 18940
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Unable to change any filters for a tune.

Post by Spunkster »

Download the software form the Software section of the website and when you install it make sure you install the calibrations for your vehicle.

Post Reply