Convert tables Fuel MAP a AFM

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
tiozes
Posts: 14
Joined: Tue Dec 27, 2011 6:35 pm

Convert tables Fuel MAP a AFM

Post by tiozes » Sat Apr 01, 2017 4:35 am

Hi,
I have an FN2 with turbo with cal RACE and I want to put AFM calibration using IAT sensor and to deactivate AFM, how do I convert the fuel tables for a correct operation?
regards

User avatar
R-12914
Posts: 348
Joined: Sun Dec 01, 2013 12:13 pm
Location: Germany/Bavaria

Re: Convert tables Fuel MAP a AFM

Post by R-12914 » Sun Apr 02, 2017 4:11 am

You must make a fully retune!
2008 Honda Civic TypeR FN2
Rotrex C30-94 supercharged with relocated IAT
Powered by ASNU 092/FP330E fuel pump & ASNU 090/750cc fuel injectors
------------------------
ECU: 37820-RSP-E03
Flashpro: FP-SI-INT-21153
Software: 3.4.7.0
Firmware: 169

mladjan
Posts: 120
Joined: Fri Sep 23, 2016 7:16 am

Re: Convert tables Fuel MAP a AFM

Post by mladjan » Mon Apr 03, 2017 10:14 am

Ok, it should be retuned, but can someone post some guidance which settings in the map itself are different? What we should be aware when doing this conversion?
I also have rotrex supercharged fn2 with race calibration, and would like to create one more map which is Hybrid.
If I copy/paste tables, will car be drivable for tuning, or safe at least?

typer86
Posts: 312
Joined: Sun Oct 28, 2012 3:17 pm

Re: Convert tables Fuel MAP a AFM

Post by typer86 » Tue Apr 04, 2017 1:36 pm

Yes and yes. But use the vtc profile and ignition what I sent to you ;)
Lock cams 50 and Rev it at first to 5000 or 6000 RPM and watch the lambda is 0.80...
Adjust the fuel and repeat this for all other cam angles

tiozes
Posts: 14
Joined: Tue Dec 27, 2011 6:35 pm

Re: Convert tables Fuel MAP a AFM

Post by tiozes » Thu Aug 17, 2017 6:00 pm

To work the AFM sensor has to be installed? Or can I remove it and have only the MAP sensor?

User avatar
Spunkster
Site Admin
Posts: 17993
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Convert tables Fuel MAP a AFM

Post by Spunkster » Fri Aug 18, 2017 9:29 am

You can disable it, there really is no need to completely remove it. IT contains the IAT sensor so if you do remove it, you must wire in a proper IAT sensor as well.

typer86
Posts: 312
Joined: Sun Oct 28, 2012 3:17 pm

Re: Convert tables Fuel MAP a AFM

Post by typer86 » Wed Aug 23, 2017 3:14 am

Spunkster wrote:
Fri Aug 18, 2017 9:29 am
You can disable it, there really is no need to completely remove it. IT contains the AIT sensor so if you do remove it, you must wire in a proper IAT sensor as well.
Yes IAT relocation is recommended...

Post Reply