Skunk2 Intake Tune 09 Si

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
Yungtempo
Posts: 15
Joined: Thu May 03, 2018 1:58 am

Skunk2 Intake Tune 09 Si

Post by Yungtempo » Thu May 03, 2018 2:03 am

I recently installed my Skunk2 Intake along with a Hondata basemap. No matter what intake calibration I use it ends up running lean. It's a 3.5 inch diameter cold air intake and if anyone could help me out it would be greatly appreciated.

User avatar
Spunkster
Site Admin
Posts: 17212
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Skunk2 Intake Tune 09 Si

Post by Spunkster » Thu May 03, 2018 9:21 am

It sounds like it will need additional tuning on the dyno. You should discuss this issue with your tuner.

Yungtempo
Posts: 15
Joined: Thu May 03, 2018 1:58 am

Re: Skunk2 Intake Tune 09 Si

Post by Yungtempo » Mon May 07, 2018 7:34 am

In case anyone has the same problem, I didn't have race tunes checked and was only choosing MAF based tunes. The intake is too big for the MAF to compensate so you have to run it on a MAP based tune. After I did that the A/F ratios were much better.

dfon
Posts: 1
Joined: Sat Jun 23, 2018 12:40 am

Re: Skunk2 Intake Tune 09 Si

Post by dfon » Sat Jun 23, 2018 1:17 am

so what tune did you use and where are your a/f at now?

Post Reply