Page 2 of 2

Re: 08 Civic si Boltons Datalogs

Posted: Sat Jul 07, 2018 9:42 am
by K20Otero
This is the WOT 3rd gear log, Ill post the rest when I get home.
WOT-3rd gear.fpdl
(110.26 KiB) Downloaded 32 times

Re: 08 Civic si Boltons Datalogs

Posted: Sat Jul 07, 2018 9:51 pm
by K20Otero
Tons of driving today. here are the logs.
datalog0031.fpdl
(2.45 MiB) Downloaded 23 times
datalog0032.fpdl
(2.31 MiB) Downloaded 20 times
datalog0033.fpdl
(195.9 KiB) Downloaded 21 times
datalog0034.fpdl
(860.64 KiB) Downloaded 20 times

Re: 08 Civic si Boltons Datalogs

Posted: Sat Jul 07, 2018 9:51 pm
by K20Otero
datalog0035.fpdl
(1.65 MiB) Downloaded 23 times
datalog0036.fpdl
(1.96 MiB) Downloaded 21 times
datalog0037.fpdl
(4.7 MiB) Downloaded 23 times

Re: 08 Civic si Boltons Datalogs

Posted: Mon Jul 09, 2018 12:56 pm
by devan
Here we go. Please include another WOT pull log; same procedures as the first.

Re: 08 Civic si Boltons Datalogs

Posted: Tue Jul 10, 2018 6:58 pm
by K20Otero
Here is another WOT log, had 2 but one got corrupted somehow.
WOT-3rd_2.fpdl
(93.09 KiB) Downloaded 33 times

Re: 08 Civic si Boltons Datalogs

Posted: Thu Jul 12, 2018 6:04 am
by typer86
Lot of todos which I recommend to tune:

Engine is running a bit to lean - I did not recommend to tune the K20 in WOT to lambda 0.90 / 0.88!
I have noticed most power and less/no knocks at lambda 0.86/0.85 (AF.corr)

Then the VTC profile is totally bumpy. The cam is unable to jump around 0 to 30 degrees in so quick.
Each machine need a sinus based curve.

- injector dead time
> should be increased for smooth out gas pedal
- Throttle > Overrun cutoff map
> should be tuned for more comfort and better idle
- ignition profile
> similar like VTC profile to bumpy - the engine is unable to use this.
> closed loop engine is running 2 to 6+% to lean. (S.TRIM tend to jumping into lean section)

Re: 08 Civic si Boltons Datalogs

Posted: Thu Jul 12, 2018 10:55 am
by devan
Thanks for the reply! Currently making those edits! :) Most of the tune is the MAP based Hondata Skunk2 tune with fueling/ignition changes of course. I'll post for review in a bit.

Re: 08 Civic si Boltons Datalogs

Posted: Thu Jul 12, 2018 4:29 pm
by devan
New cal attach. Adjusted WOT values to target 12.5:1 or Lambda 0.85

This car was initially VERY rich so I pulled a bit fuel. I over shot into the lean area and have been gradually adding fuel with each iteration. The part throttle fuel (S. trims) isn't done yet but I'm close! :) I did add fuel to those lean areas.

As for the VTC profile, I kept it stock. I feel like to get more ideal angles, you would need a dyno. I did notice that Hondata has an updated profile for the Skunk2 cal. It didn't look right to me so I retained the first version. (2.9.7 vs 3.1.1)

Ignition- I read that the "stock ignition" is close to optimum. I have been pulling timing in knock areas (about 0.5 to 1 degree). Would you recommend the ignition values from the skunk2 MAF based tune?

If you have a better VTC/Ignition profiles, throw them my way. I'm always looking to improve! :)

Injector opening time was kept the Hondata values. Would adding a few microseconds make a substantial difference on stock injectors?

Overrun cutoff MAP- still hondata. I've studied a handful of MAP based tunes that use these same values. Again, any recommendations/tuning strategies are appreciated! :)

Cheers,
~D

Re: 08 Civic si Boltons Datalogs

Posted: Fri Jul 13, 2018 5:45 pm
by K20Otero
No logs today. My bank 1 02 sensor died p0135 heater sensor code. Should have it replaced tomorrow.

Re: 08 Civic si Boltons Datalogs

Posted: Sat Sep 08, 2018 5:38 pm
by K20Otero
Check engine light was a wiring issue. Header melted a wire which caused a fuse to blow and now its all fixed and im ready to datalog again. Should be posting more logs soon!

Re: 08 Civic si Boltons Datalogs

Posted: Thu Sep 13, 2018 10:40 pm
by K20Otero
Just a quick log from a drive home, Stock 9th gen si tried to highway battle me on the way home ;) had to show him my license plate
-1SlowSi
datalog0038.fpdl
(2.13 MiB) Downloaded 41 times