07 Basemap

Calibrations for FlashPro Manager - Use all calibrations at your own risk (dyno tuning recommended)

Post Reply
bdy099
Posts: 2
Joined: Sat Mar 09, 2019 4:12 pm

07 Basemap

Post by bdy099 » Sat Mar 09, 2019 4:16 pm

Currently have a full bolt on FG2 and am running the skunk2 catback, header, CAI basemap.

Mods:
Skunk2 Alpha
Q300
Injen CAI

If someone has a similar setup and has a decent map I would like to try it out. I live in Arizona as well so cold weather people probably should not link tunes. Thanks

EFICU
Posts: 60
Joined: Mon Feb 25, 2019 10:14 pm

Re: 07 Basemap

Post by EFICU » Sat Mar 09, 2019 6:28 pm

PM sent.

bdy099
Posts: 2
Joined: Sat Mar 09, 2019 4:12 pm

Re: 07 Basemap

Post by bdy099 » Tue Mar 12, 2019 1:50 pm

can't use pms right now this is a new account as I lost my old login info. I am running a base map. actually knock sensor just started going off 2 days ago and I have been scared to drive the thing. I get some sort of rattle/metallic sound from the driver side of the engine bay when im in gear and around 2.8k and 3.2k rpm, it will flash the programmed cel knock sensor and then go away once im past the rpm range. only happens when more than 30-40% throttle and happens in lower gears only. I might of put 87 in it but im not totally sure cause that would be a first for me. Tank is about half gone.

EFICU
Posts: 60
Joined: Mon Feb 25, 2019 10:14 pm

Re: 07 Basemap

Post by EFICU » Wed Mar 13, 2019 8:53 pm

Okay. What email address can I reach you at?

Post Reply