Hondata help on Part Throttle Fuel Tuning (MAP)
Posted: Thu Sep 22, 2016 8:01 am
In the help portal of Hondata it was written as follows:
Preparation
• Open your calibration, and display the low speed cam fuel tables (F5).
• Find what cam angles your calibration uses - normally it will be 0, 10, 20, 30, 40 or 0, 15, 30, 40, 50 degrees.
Cam angles
Cam angles
• Starting with the first cam angle, lock the cam to the setting by setting the low speed cam angle table to this value.
Cam locked to 15 degrees
https://www.hondata.com/help/flashpro/i ... e_fuel.htm
Is there anyone could elaborate a bit more on this?
Does it mean for each cam angle table say table 30 degree, do I fill up the table and locked the cam to 30 degree as preparation before doing a datalog run or it means I should locked all cam angle table say 15, 30, 40 and 50 degree to 15 degree then do a datalog run with?
Any advise is appreciated.
Preparation
• Open your calibration, and display the low speed cam fuel tables (F5).
• Find what cam angles your calibration uses - normally it will be 0, 10, 20, 30, 40 or 0, 15, 30, 40, 50 degrees.
Cam angles
Cam angles
• Starting with the first cam angle, lock the cam to the setting by setting the low speed cam angle table to this value.
Cam locked to 15 degrees
https://www.hondata.com/help/flashpro/i ... e_fuel.htm
Is there anyone could elaborate a bit more on this?
Does it mean for each cam angle table say table 30 degree, do I fill up the table and locked the cam to 30 degree as preparation before doing a datalog run or it means I should locked all cam angle table say 15, 30, 40 and 50 degree to 15 degree then do a datalog run with?
Any advise is appreciated.