Fn2 cruise control not working?

[goppe]

Hi, my cruise control doesn't work anymore... I have tried set Fn2 euro gear ratios but didn't work either.
I have a 4.76 final drive from EP3.

Do I need to set gear ratios from civic si and change the 6's gear ratio?

[R-12914]

What is happening, if you use the FN2 gear-ratios and your 4.76 as final drive like this?:

final.JPG (23.05 KiB) Viewed 8260 times

[goppe]

Did not work with civic si and changed 6s gear and it did not work with the sugestion you came with :/ anyone know how to fix this?

[R-12914]

Do you have push (activate) your cruise contol on your steering wheel like this?:

CruiseControl.jpg (518.12 KiB) Viewed 8224 times

[goppe]

Yes that works but the cruise control will not kick in when I press the set button.

It worked in october last year, the car has been in the garage over the winter and I took it out in the beginning of april, the cruise didn't work now.
How is the wiring system for the whole cruise setup, maybe I have disconnected some wires by mistake?

I have tried return ecu to stock and upload it again, I have a feeling that the fault is from the calibration... Maybe I should try and disconnect cruise in my calibration and upload and then take it for a drive and later upload again when cruise is connected in the calibration?

[R-12914]

Maybe I should try and disconnect cruise in my calibration and upload and then take it for a drive and later upload again when cruise is connected in the calibration?

Yes, try it!

[goppe]

Still not working...

[goppe]

Anyone know what to check for ?

[R-12914]

Can you please add your Calibration?

[goppe]

It has worked before with civic si gear ratios, I have 4.76 final drive.

[R-12914]

Do you have try a MAF or MAF calibration with MAP fuel tables?
If not, please try it!

Please have a look, if the problem with it is yet!

You use a MAP calibration!
MAP calibrations are for race use only and this one not have some features!

[goppe]

It has worked before with MAP calibration and my friend has MAP calibration and all features works. Both cruise and trip meter.

My trip meter works with this calibration but not the cruise. Cruise has stopped working when I uploaded a "new" calibration to my car in April.

[typer86]

1. install the latest beta version of hondata
2. restore your ecu back to stock - switch off ignition and wait 1 minute

3. Then: upload the RSP calibration only (which I provide you in the other thread) - MAP (race cal) not supported for FN2
4. Record the drive for 20 - 30 minutes (start logging if the engine is fully warmed up!)
5. upload the log here

[R-12914]

In addition you can try to disconnect the battery, wait a few minutes and reconnect it!

Then reupload your map!