Which settings you are using for this screen (attached) for supercharged k20 tuning?
Lambda overlay settings
Re: Lambda overlay settings
Why do you ask this?
This is not a screenshot of a Flashpro-Manager window!
This is not a screenshot of a Flashpro-Manager window!
2008 Honda Civic TypeR FN2
Rotrex C30-94 supercharged with relocated IAT
Powered by ASNU 092/FP330E fuel pump & ASNU 090/750cc fuel injectors
------------------------
ECU: 37820-RSP-E02
Flashpro: FP-SI-INT-21153
Software: 3.6.1.0
Firmware: 185
Rotrex C30-94 supercharged with relocated IAT
Powered by ASNU 092/FP330E fuel pump & ASNU 090/750cc fuel injectors
------------------------
ECU: 37820-RSP-E02
Flashpro: FP-SI-INT-21153
Software: 3.6.1.0
Firmware: 185
Re: Lambda overlay settings
Hehehe, yes, it is :)
Options -> Settings and select Lambda Overlay tab.
When you tuning, there is a lambda overlay which can speed up your process on low cam. But on high cam, you are trying to achieve one value on 0-6 col, second value from 7 do 10 col, and another from 10 to X (depending on boost).
Options -> Settings and select Lambda Overlay tab.
When you tuning, there is a lambda overlay which can speed up your process on low cam. But on high cam, you are trying to achieve one value on 0-6 col, second value from 7 do 10 col, and another from 10 to X (depending on boost).
Re: Lambda overlay settings
My tune for rotrex SC kits:
Idle lambda 1
Low load lambda 0.97 to 0.93/0.91 (col 1-7) go smooth to enrich the mixture to go into the open loop at the end of col 7...
Medium load 0.85 to 0.83 (col 8-9) open loop
High load 0.81 to 0.80/0.79 (col 10-20) open loop
Hope it helps
Idle lambda 1
Low load lambda 0.97 to 0.93/0.91 (col 1-7) go smooth to enrich the mixture to go into the open loop at the end of col 7...
Medium load 0.85 to 0.83 (col 8-9) open loop
High load 0.81 to 0.80/0.79 (col 10-20) open loop
Hope it helps