AEM Wideband as primary

FlashPro questions & answers specific to the FN2 European Civic Type R
Post Reply
D33@+H-Kn1gH+
Posts: 23
Joined: Thu Mar 09, 2017 4:05 am

AEM Wideband as primary

Post by D33@+H-Kn1gH+ »

I am trying to cancel the OEM primary O2 sensor and connect the AEM wideband (brown & white wires) to the factory O2 sensor blue plug on the car in order for the ECU to get the signal directly from the wideband but the flashpro manager doesn't read any value on idle. It keeps reading 14.7 AFR without changing at all and the digital display shows 9.6 AFR.
Am I missing something?
User avatar
Spunkster
Site Admin
Posts: 22745
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: AEM Wideband as primary

Post by Spunkster »

You cannot do this. It cannot run closed loop from anything but a factory O2 sensor. You need to keep the factory sensor connected and you can use one of the inputs listed in the calibration window under Lambda in the Closed Loop section to input the aftermarket wideband signal to the ECU for datalogging only.
D33@+H-Kn1gH+
Posts: 23
Joined: Thu Mar 09, 2017 4:05 am

Re: AEM Wideband as primary

Post by D33@+H-Kn1gH+ »

Spunkster wrote: Mon Jul 08, 2019 4:39 pm You cannot do this. It cannot run closed loop from anything but a factory O2 sensor. You need to keep the factory sensor connected and you can use one of the inputs listed in the calibration window under Lambda in the Closed Loop section to input the aftermarket wideband signal to the ECU for datalogging only.
Thank you very much
Post Reply