Page 1 of 1

FP Group N calibration FN2 same as in Group N Reflashed ECU?

Posted: Fri Jul 10, 2009 8:06 am
by walter
I think that there is a problem with Group N calibration for FN2 in FlashPro. My car detonates when engine enters VTEC @3800rpm. I think that it is not the same calibration which was used in Group N reflashed ECU. And it seems that there is a flat spot at 2500-3500rpm.

My mods: Toda header, Milltek sport stainless steel exhaust, Hondata heatshield gasket, FlashPro, Toda hi-power clutch/flywheel kit.

With that mods Group N Reflashed ECU worked fine.

Soon I'll make datalog and put it here.

Posted: Fri Jul 10, 2009 8:44 am
by walter
Here is my datalog. When I press accelerator slightly during entering VTEC @3800rpm my car jerks from 3800 till 4200rpm and there is some detonation heard in exhaust system. When I press accelerator harder during entering VTEC there is no so much jerking and detonation.
Maybe you can see from datalog what is wrong?

Thanks!

Posted: Sat May 22, 2010 8:13 am
by e-z
i registered the same difference like you...
the switch point is lower then the reflash ecu has...

else the full trottle sensity is different to the oem calib.