I am having a little troublew with the boost control feature. I had been on the phone with Matt from Hondata yesterday and he had me try taking out the diode in line and either way i still have the same problem.
From the top
I setup the solenoid
#1 on the solenoid is t into the bottom of the wastegate and the vaccum source
#2 on the solenoid is on the top of the wastegate
#3 is open
I have one with with a fused 10amp fuse on b2 on the ecu plus the other wire is grounded to chassis
I get a boost spike even at 1% car goes right to boost cut which I have set at 16psi. The spring pressure on the wastegate is 8psi from the spring.
I have tried every duty cycle I could. 1,5,10,15,20,25,30,40,50 etc and still get the same result.
I have tried 3 diffrent solenoide I can get them to click from the ecu by making activation pressure -14.7 so I know I am wired correctly.
Can anyone shed some light on this? I even installed the lines back the way they were and I get spring pressure.
Any help would be appreciated.
FlashPro Manager software
2 posts • Page 1 of 1