Analog Input? How to datalog methanol injection engagement?

FlashPro Manager software
Post Reply
jomo
Posts: 3
Joined: Fri Feb 14, 2014 7:54 am

Analog Input? How to datalog methanol injection engagement?

Post by jomo » Thu Nov 13, 2014 8:25 am

Is there a way to datalog the on/off engagement of methanol injection?

Currently, I have methanol injection to engage on an independent boost switch, but I want to incorporate it into Flashpro. Since there is no apparent feature to control methanol injection such as nitrous control in K-Pro, is there at least a way to monitor when methanol engages so I can view it in my graph?

Just a thought-- I'm already using the EGRL input for a wideband input. Are there any other inputs available?

Any ideas/suggestions are greatly appreciated.

User avatar
Spunkster
Site Admin
Posts: 17935
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Analog Input? How to datalog methanol injection engageme

Post by Spunkster » Thu Nov 13, 2014 11:10 am

There really is no easy way of doing this as analog inputs are 0-5v and the injection kit will be 12v.

shind3
Posts: 109
Joined: Mon Jun 30, 2014 8:02 am
Location: Pittsburgh, PA

Re: Analog Input? How to datalog methanol injection engagement?

Post by shind3 » Fri Nov 21, 2014 12:01 pm

You could just switch to a manual boost controller and use your current boost control solenoid driver to run a MAP vs RPM ADI map. You would need support from Hondata to do so though, so good luck with that. lol

Post Reply