How can I get column 10 activated on fuel table

FlashPro Manager software
Post Reply
bian.yy
Posts: 48
Joined: Tue Jan 12, 2016 6:04 pm

How can I get column 10 activated on fuel table

Post by bian.yy »

Hi Hondata

How can I get my column 10 of delta fuel table activated during road tuning WOT. I am already push down to floor, you can look on tplate data.
Setup is K24A2 + 421 header.
Attachments
MyK24A_Tune_3000.fpcal
(15.69 KiB) Downloaded 133 times
MyK24A_Tune_High.fpdl
(2 MiB) Downloaded 122 times
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: How can I get column 10 activated on fuel table

Post by Hondata »

If the air pressure is not high enough or you have intake restriction then you will not reach column 10. This is normal.
Hondata
bian.yy
Posts: 48
Joined: Tue Jan 12, 2016 6:04 pm

Re: How can I get column 10 activated on fuel table

Post by bian.yy »

Hondata wrote: Fri Sep 01, 2017 8:35 am If the air pressure is not high enough or you have intake restriction then you will not reach column 10. This is normal.
Ok, I understand, because of my intake is still stock, do you have any experience if I change to CAI for higher flow will it obviously decrease low end torque from 1000 to 3000?
mladjan
Posts: 120
Joined: Fri Sep 23, 2016 7:16 am

Re: How can I get column 10 activated on fuel table

Post by mladjan »

When you "open" exhaust, engine will need more air, and stock intake is restriction. CAI may help (with good velocity), but also bigger throttle plate and ported intake manifold will help. Try first with CAI, its cheeper.
bixer
Posts: 10
Joined: Tue Aug 22, 2017 1:02 am

Re: How can I get column 10 activated on fuel table

Post by bixer »

on NA engine , too large throttle plate will decrease the air flow velocity and this will further decrease low end torque by geopartizing the valve overlap in that area.
User avatar
Hondata
Site Admin
Posts: 10434
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: How can I get column 10 activated on fuel table

Post by Hondata »

If you live above about 1200 feet then you're not going to get to column 10 because of the air pressure, depending on the atmospheric conditions. It is normal.
Hondata
bian.yy
Posts: 48
Joined: Tue Jan 12, 2016 6:04 pm

Re: How can I get column 10 activated on fuel table

Post by bian.yy »

Yes, I am living 1345 ft. So I don't need to care about column 10 then.
Post Reply