09 RDX base maps
-
- Posts: 9
- Joined: Fri Jan 22, 2016 3:06 pm
Re: 09 RDX base maps
The limits of the factory 14T turbo are another few psi. Some guys have run upwards of 20 psi in the early rpm range tapering down to 12-13 psi at redline.
-
- Posts: 22
- Joined: Sat Jul 21, 2018 4:29 pm
Re: 09 RDX base maps
Thank you for your response, gearhead. I didn't push it past the 15.5, and it started tripping my MAP sensor whenever I would be above 4500RPM in 3rd gear. So I just put it back to 2.0. I installed the ETS TMIC this weekend, and haven't really had a chance to see if there have been any noticeable hp gains while driving. Is it advisable to get a tune after installing this, or is it "plug n play," for lack of a better phrase?
-
- Posts: 22
- Joined: Sat Jul 21, 2018 4:29 pm
Re: 09 RDX base maps
I am installing the deatschwerks 300lph fuel pump, and 600cc injectors with rywire harness. Until I get a tune (in about a week), is it safe to use the flashpro 600cc calibration, with my bolt on's? Its my daily car and I still need to commute for a few days post install. I have: CBE, RV6 DP, ETS TMIC, K&N CAI
Re: 09 RDX base maps
You will have to Datalog and make sure the AF ratio is safe and that there is no knock.
-
- Posts: 22
- Joined: Sat Jul 21, 2018 4:29 pm
Re: 09 RDX base maps
Got it. I have since started an etune, and am pleased w/results so far. There was a fluctuating, and odd decrease w/ voltage, resulting in my ABS, VSA, SH-AWD CEL coming on. Is there a way to see HP gains other than a dyno?
Re: 09 RDX base maps
A dyno is the only way to accurately measure the power output.