Cam angle map info??

FlashPro Manager software
User avatar
Spunkster
Site Admin
Posts: 17842
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Cam angle map info??

Post by Spunkster » Wed May 08, 2019 4:33 pm

There is no drop down for this in in FlashPro Manager.

The screenshot you have posted is of Kmanager which is not used for a FN2.

Typersam
Posts: 34
Joined: Sun Mar 31, 2019 2:46 pm

Re: Cam angle map info??

Post by Typersam » Mon May 20, 2019 11:12 am

Yeh soz this was a screenshot taken from a dc5 but on the fn2 you still have the 0-50 degree cam angle maps right??

User avatar
Spunkster
Site Admin
Posts: 17842
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Cam angle map info??

Post by Spunkster » Mon May 20, 2019 12:20 pm

correct.

Typersam
Posts: 34
Joined: Sun Mar 31, 2019 2:46 pm

Re: Cam angle map info??

Post by Typersam » Wed May 22, 2019 3:36 pm

Soi giess the same question would apply won't it bro?

Lomanrams21
Posts: 4
Joined: Mon May 20, 2019 8:24 pm

Re: Cam angle map info??

Post by Lomanrams21 » Sat May 25, 2019 2:57 pm

For the 2013 Civic SI I was reading that you want the low cam angle around 12 nd the high cam angle around 37... This was what hondata had prefered, do they have a cam angle map that you can just load onto the FlashPro??? or is it something you have to tune into it yourself? just trying to get the best out of my VTEC. Thank You!

User avatar
Spunkster
Site Admin
Posts: 17842
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Cam angle map info??

Post by Spunkster » Tue May 28, 2019 9:14 am

There are base maps built into the software you can use, or you can tune yourself on the dyno.

Typersam
Posts: 34
Joined: Sun Mar 31, 2019 2:46 pm

Re: Cam angle map info??

Post by Typersam » Sun Jun 02, 2019 10:16 am

So as someone mentioned should I set all cam angle to 0 do a run then to 10 fo a run then to 20 do a run and so forth then just overlay results and see what makes peak torque etc at any give point?

Typersam
Posts: 34
Joined: Sun Mar 31, 2019 2:46 pm

Re: Cam angle map info??

Post by Typersam » Mon Jun 03, 2019 6:13 am

Am I getting hot or am I still way off lads?

User avatar
Spunkster
Site Admin
Posts: 17842
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Cam angle map info??

Post by Spunkster » Mon Jun 03, 2019 9:35 am

YEs you can do that but each cam angle must be tuned for optimum power.

Post Reply