Cam ignition table help please

FlashPro Manager software
Post Reply
Typersam
Posts: 34
Joined: Sun Mar 31, 2019 2:46 pm

Cam ignition table help please

Post by Typersam »

So learning through the course and enjoying it very much.

Watching through the hondata worked example and I can't see why when we tune the ignition on the low speed cam map we still tune the high rpm sights as by that point you've switched cam and are running on the high speed map? Help me understand it better please lads
User avatar
Spunkster
Site Admin
Posts: 22737
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Cam ignition table help please

Post by Spunkster »

I don't understand the question.
curtusz
Posts: 211
Joined: Sat Jun 01, 2013 10:14 am
Location: Wakefield/Leeds uk

Re: Cam ignition table help please

Post by curtusz »

You can do it that way. You don't exactly need to tune it .. but what if your vtec solenoid stops working and car doesnt go in to high cam. And you lean out bad ? Its just a fail safe to tune as much as you can
Typersam
Posts: 34
Joined: Sun Mar 31, 2019 2:46 pm

Re: Cam ignition table help please

Post by Typersam »

@spunkster.... I was asking why there are above above let's say 6000rpm on the low cam map when at 6000rpm we would have switched to high cam by then
User avatar
Spunkster
Site Admin
Posts: 22737
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Cam ignition table help please

Post by Spunkster »

Because you can be on the low cam at higher RPM if you are not at wide open throttle.
Typersam
Posts: 34
Joined: Sun Mar 31, 2019 2:46 pm

Re: Cam ignition table help please

Post by Typersam »

Yeh I think I get it now...as there are 2 vtec "windows" one for low load high rpm and One for high load low rpm it may end up using those sights if on light throttle high rpm??
User avatar
Spunkster
Site Admin
Posts: 22737
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: Cam ignition table help please

Post by Spunkster »

correct.
Typersam
Posts: 34
Joined: Sun Mar 31, 2019 2:46 pm

Re: Cam ignition table help please

Post by Typersam »

Thanks pal 👍
Post Reply