HONDATA FLASHPRO CANT CONNECT TO OB2
HONDATA FLASHPRO CANT CONNECT TO OB2
I have a 2010 Honda Civic Si. I have my Hondata Flashpro for just over a year. It was working fine until a couple months ago, when i plugged my flashpro into my car OBD2, the power light on the flashpro started to intermittenly stay on. I had to keep wiggling and hold the flashpro harness at a certain spot to make the power light stay on. Now, the Flashpro wont connect to my OBD2. I have to connect my flashpro to my car OBD2 and to my laptop USB together to make the flashpro power light come on. To upload a calibration, i have to connect the flashpro to my OBD2 and computer at the same time. Upload the calibration onto my flashpro. While the flashpro is connected to the computer and OBD2, press the program on the flashpro. Without it connected to the computer, i cannot upload a calibration.. I checked all related fuses. the OBD2 port for push/bent pins, and the pins on the flashpro. No fault present. I cant do "Live Tuning", "Datalogging", use the "bluetooth" application. I hope i can get this resolved, knowing that this hondata flashpro was not cheap.
Re: HONDATA FLASHPRO CANT CONNECT TO OB2
Have you tried the FlashPro in a different vehicle to see if the connection is any different?
Re: HONDATA FLASHPRO CANT CONNECT TO OB2
Not yet, I will update when I get the chance to do that. Thanks!
Re: HONDATA FLASHPRO CANT CONNECT TO OB2
Send an email to support <at> hondata.com with the following and I will issue an RMA and give you further
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
Include a link to this thread.
instructions:
Name:
Address:
Phone:
Email:
Serial#:
Description of problem:
Include a link to this thread.