2019 CTR - Descending knock steps

FlashPro Manager software
Post Reply
Juncura1
Posts: 33
Joined: Sat Mar 23, 2019 4:43 pm

2019 CTR - Descending knock steps

Post by Juncura1 »

Hello,

I'm seeing descending knock steps in cylinders 2/4 at WOT beginning at 2600rpm and stepping down until 6k rpm. I'm assuming that this is noise as it is decreasing and not increasing. However, I am hesitant to lower the knock sensitivity in these 2 cylinders. Thoughts?

- I've tried to upload the datalog but it's telling me that it's too large (18,547KB).
User avatar
Hondata
Site Admin
Posts: 10428
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: 2019 CTR - Descending knock steps

Post by Hondata »

Trim the datalog so it is smaller.
Hondata
Juncura1
Posts: 33
Joined: Sat Mar 23, 2019 4:43 pm

Re: 2019 CTR - Descending knock steps

Post by Juncura1 »

I got it figured out. My apologies for not updating the thread.

Thanks again!
Post Reply