Page 1 of 1

Knock Control % - not going to 0 after reflash

Posted: Sun Aug 24, 2014 10:59 pm
by shind3
It seems that my knock control % is perpetually stuck at 55% even after I upload a new calibration. How do I reset it to 0?

Re: Knock Control % - not going to 0 after reflash

Posted: Mon Aug 25, 2014 7:30 am
by Hondata
It starts out at 55%, and then gets adjusted based on running conditions. Post your calibration.

Re: Knock Control % - not going to 0 after reflash

Posted: Mon Aug 25, 2014 9:32 am
by shind3
Oh, then it's just me being impatient. I've made one revision per day for the past few days and I'm probably just not giving it enough time to learn down to 0%. I wish there was a way to set the initial value to 0 so changes to timing maps can be checked immediately after a reflash.