rich afr with toda calibration

FlashPro questions & answers specific to the 2006-2009 (US, UK, Asia) S2000
Post Reply
jayson415
Posts: 4
Joined: Wed Oct 31, 2018 12:11 pm

rich afr with toda calibration

Post by jayson415 »

Hi everyone, I have a 2006 Honda s2000 with fujita CAI,Toda header and invidia q300 exhaust,i uploaded the toda calibration and did a datalog and as far I know for a NA engine an afr of 10.1-10.4,is very rich or is this normal with this canned Toda calibration... can some one please verify the datalog and point me in the right direction, thanks in advance.
Attachments
datalog0001 toda calibration rich afr.fpdl
(2.16 MiB) Downloaded 52 times

User avatar
Spunkster
Site Admin
Posts: 19097
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: rich afr with toda calibration

Post by Spunkster »

It is a bit rich for a naturally aspirated setup. You can try taking some fuel out, but your best bet would be to get this tuned on the dyno.

jayson415
Posts: 4
Joined: Wed Oct 31, 2018 12:11 pm

Re: rich afr with toda calibration

Post by jayson415 »

Will do in about a month, thanks.

jayson415
Posts: 4
Joined: Wed Oct 31, 2018 12:11 pm

Re: rich afr with toda calibration

Post by jayson415 »

One more question, if I go to settings, then overlay lambda input...closed loop and open loop what settings I use, stock sensor or corrected stock sensor?

User avatar
Spunkster
Site Admin
Posts: 19097
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: rich afr with toda calibration

Post by Spunkster »

use the stock sensor.

jayson415
Posts: 4
Joined: Wed Oct 31, 2018 12:11 pm

Re: rich afr with toda calibration

Post by jayson415 »

Thanks again!

Post Reply