Page 1 of 1

boost activation question

Posted: Mon Mar 18, 2019 12:23 pm
by andyroosim
another question, i may be overthinking this, but in the "flashpro help" it says to set the activation boost pressure slightly over atmospheric pressure which is 14.7psi at sea level.

I want my solenoid to kick in around 5psi of boost. Should I set the boost activation pressure to 5psi or 14.7psi? Thanks.

Re: boost activation question

Posted: Tue Mar 19, 2019 9:35 am
by Spunkster
It would be 5 psi as PSI cannot measure below atmospheric pressure.

Re: boost activation question

Posted: Tue Mar 19, 2019 9:46 am
by andyroosim
i was never good at chemistry...math...whatever this question would fall under haha. thanks!