New CPR kit, hard crank. No start up!

Hondata CPR (Coil Pack Retrofit) support
Post Reply
j_cvstillo
Posts: 6
Joined: Mon Sep 03, 2018 1:24 pm

New CPR kit, hard crank. No start up!

Post by j_cvstillo » Sun Sep 16, 2018 12:49 am

I installed a brand new cpr kit. I wired it up according to hondata. Power A25, Ground A23, ICM A22, Sync A16, ground on the thermostat housing, Tac & 12v power on the distributor. My problem is that I’m cranking the car it’s only cranking and not turning over. Power light and ignition light turns on the cpr. Sync flashes while cranking, I also programmed it from Smanager like you’re supposed too. I’m running a P28-A02 S300v3 with a Q37 transmitter integrated. I am running out of options, I sent my calibration to my tunner and he said everything looks “normal”. If anybody can help me I will gladly appreciate it.

j_cvstillo
Posts: 6
Joined: Mon Sep 03, 2018 1:24 pm

Re: New CPR kit, hard crank. No start up!

Post by j_cvstillo » Sun Sep 16, 2018 1:02 am

“Transistor” sorry

User avatar
Spunkster
Site Admin
Posts: 17462
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: New CPR kit, hard crank. No start up!

Post by Spunkster » Mon Sep 17, 2018 11:05 am

Have you followed the troubleshooting steps at: http://www.hondata.com/help/cpr/troubleshooting.htm

Post Reply