Page 1 of 1
Going back to stock re: CAN adapter
Posted: Mon Aug 04, 2014 7:10 pm
by billj457
Hello, I was wondering if I needed to re-pin my OBD2 port (2006 6MT) back to stock before or after swapping my stock ecu back in the car? Or could I just leave the CAN adapter hooked up?
Thanks!
Re: Going back to stock re: CAN adapter
Posted: Tue Aug 05, 2014 9:27 am
by Spunkster
You can just leave it, it will not hurt anything.
Re: Going back to stock re: CAN adapter
Posted: Tue Aug 05, 2014 12:20 pm
by billj457
Great, thanks for the quick reply.
Re: Going back to stock re: CAN adapter
Posted: Wed Mar 11, 2015 11:16 pm
by cl9_TSX
bump
My situation is a bit different from the OP. I don't have my original 04 ECU so I will need to buy a used one. Will the dealer still be able to do ecu - immobilizer sync process if I left the adapter in?
Re: Going back to stock re: CAN adapter
Posted: Thu Mar 12, 2015 9:08 am
by Spunkster
Yes it will still work as it should.