Knock count on stock equivalent calibration

FlashPro questions & answers specific to the 2010 CR-Z (US, Euro & Asia)
Post Reply
lvxnid
Posts: 4
Joined: Wed May 15, 2013 7:17 am

Knock count on stock equivalent calibration

Post by lvxnid » Wed May 22, 2013 8:27 am

Hi guys, I am experiencing knock count using CR-Z stock equivalent calibration, CRZ-Asia-1. Knock counts will be ranging from 9 to 24 knocks for 25 minute drive. If I returned it to stock ECU calibration there will be no knocks registered even for an hour drive.

Do I need to change any parameter on Flashpro base calibration in order to completely eliminate knocks just like stock ECU calibration?

Thank you in advance!

User avatar
Spunkster
Site Admin
Posts: 17943
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Knock count on stock equivalent calibration

Post by Spunkster » Wed May 22, 2013 10:01 am

A full return to stock will not have the ability to log knock counts, so this is not a good comparison. This sounds like just a tuning issue.

Post Reply