TC retard table

Post Reply
prote5
Posts: 3
Joined: Sun Jun 22, 2014 7:24 am

TC retard table

Post by prote5 » Sun Jun 22, 2014 7:39 am

Hi, i recently installed TC on civic Si 2009 and can't find TC timing retard table on software. Thanks for your help.
Attachments
fp-retard 2.gif
fp-retard 2.gif (8.36 KiB) Viewed 5621 times
fp-parameters.gif
fp-parameters.gif (6.45 KiB) Viewed 5621 times

User avatar
Hondata
Site Admin
Posts: 8818
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: TC retard table

Post by Hondata » Sun Jun 22, 2014 12:35 pm

'Options' menu, 'Show Advanced Parameters'. The select from the Calibration window.
Hondata

prote5
Posts: 3
Joined: Sun Jun 22, 2014 7:24 am

Re: TC retard table

Post by prote5 » Sun Jun 22, 2014 5:02 pm

Ok, another question... voltage offset should be the same on both devices? For example on my TC output offset is set to 1 and on flashpro is set to 0. TC is connected to A23 pin (ELD) in flashpro.

User avatar
Hondata
Site Admin
Posts: 8818
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: TC retard table

Post by Hondata » Mon Jun 23, 2014 7:12 am

The two settings are different. In the 'Traction Control' settings window, the 1V 'Output Offset' refers to the 0% slip level. The voltage offset is 0V.

In FlashPro parameters, the voltage offset is to compensate for any ground differences between the Traction Control unit and the ECU. Ideally this is 0V, otherwise it indicates a wiring problem.

When the ECU sees any voltage from 0V to 1V, slip is calculated at 0%. At 1V, slip is 10% per volt. eg 2.5V input = 15% slip. This was done to stop minor voltage fluctuations from showing a wheel slip.
Hondata

prote5
Posts: 3
Joined: Sun Jun 22, 2014 7:24 am

Re: TC retard table

Post by prote5 » Mon Jun 23, 2014 9:09 pm

Thanks for your support.. I will keep you informed

Post Reply