flash pro cant upload any calibration

2012+ US/Canadian Civic Si / 2013+ ILX
Post Reply
MSTRSPEED
Posts: 5
Joined: Sun Oct 08, 2017 12:42 pm

flash pro cant upload any calibration

Post by MSTRSPEED » Mon Oct 09, 2017 10:40 am

the unit was unlocked and after i registered, locked it to my car and uploaded a calibration last week and failed to upload to ecu it wont let me add any other calibration to the flashpro. I keep getting THE ECU HAS NOT BEEN RECORDED. CONNECT THE FLASHPRO TO THE VEHICLE AND SWICH THE IGNITION ON TO RECORD THE VIN. any help is apreciated. car is stock ecu 2014 acura ilx flashpro serial # FP-2012SI-110744

User avatar
Spunkster
Site Admin
Posts: 17653
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: flash pro cant upload any calibration

Post by Spunkster » Mon Oct 09, 2017 10:59 am

From Help, About, what is the version of software you are using?

MSTRSPEED
Posts: 5
Joined: Sun Oct 08, 2017 12:42 pm

Re: flash pro cant upload any calibration

Post by MSTRSPEED » Mon Oct 09, 2017 11:01 am

version 2.8.4.0

User avatar
Spunkster
Site Admin
Posts: 17653
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: flash pro cant upload any calibration

Post by Spunkster » Mon Oct 09, 2017 11:25 am

Have you tried uploading to the FlashPro with the laptop while it is all plugged into the vehicle with the key in the on position?

MSTRSPEED
Posts: 5
Joined: Sun Oct 08, 2017 12:42 pm

Re: flash pro cant upload any calibration

Post by MSTRSPEED » Mon Oct 09, 2017 11:28 am

tried that as well. it sayed to conect to the car and swich ignition to on even when pluged in to the car. with all the checks green on the bottom also.

User avatar
Spunkster
Site Admin
Posts: 17653
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: flash pro cant upload any calibration

Post by Spunkster » Mon Oct 09, 2017 2:04 pm

With everything plugged in and the key in the on position, go to Help and click on send information to Hondata support. Include a detailed description of the problem.

MSTRSPEED
Posts: 5
Joined: Sun Oct 08, 2017 12:42 pm

Re: flash pro cant upload any calibration

Post by MSTRSPEED » Thu Oct 12, 2017 9:32 am

i finally had time to try again, and still same issue. so i did as you suggested. Hopefully i hear back from them and get this solved. Thank you

User avatar
Spunkster
Site Admin
Posts: 17653
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: flash pro cant upload any calibration

Post by Spunkster » Thu Oct 12, 2017 10:22 am

Try Clearing DTC's and then after that completes, unplug the ECU completely wait a few seconds and plug it back in. Then see if it will work correctly.

Post Reply