Boosted 2013 Civic Si
-
- Posts: 10
- Joined: Mon May 20, 2019 8:24 pm
Boosted 2013 Civic Si
I have been trying to setup launch control and Rolling Anti lag for some roll rraces, From what I have read, you go into flasphpro and adjust the settings accordning to what you want, I have attached a screenshot, I was reading you have to hold the cruise control cancel button in order to activate it, but it will not work at all when im rolling it just revs out and when I am at a dig it just goes to the factory launch control that I can adjust in car. Even if i just setup launch control in flashpro, it doesnt matter what I set it to. The car only goes off of what I have adjusted in car. IF that makes sense. ALmost Like it wont accept the changes.
- Attachments
-
- Flashpro Calibration
- Screenshot 2021-06-27 124612.png (149.88 KiB) Viewed 965 times
-
- Posts: 8
- Joined: Sat Apr 20, 2019 5:42 am
Re: Boosted 2013 Civic Si
Question for you did sent the boost controller to the b2 pin and the wideband to the a44 pin the ecu ?