Boosted 2013 Civic Si

2012+ US/Canadian Civic Si / 2013+ ILX
Post Reply
Lomanrams21
Posts: 10
Joined: Mon May 20, 2019 8:24 pm

Boosted 2013 Civic Si

Post by Lomanrams21 »

I have been trying to setup launch control and Rolling Anti lag for some roll rraces, From what I have read, you go into flasphpro and adjust the settings accordning to what you want, I have attached a screenshot, I was reading you have to hold the cruise control cancel button in order to activate it, but it will not work at all when im rolling it just revs out and when I am at a dig it just goes to the factory launch control that I can adjust in car. Even if i just setup launch control in flashpro, it doesnt matter what I set it to. The car only goes off of what I have adjusted in car. IF that makes sense. ALmost Like it wont accept the changes.
Attachments
Flashpro Calibration
Flashpro Calibration
Screenshot 2021-06-27 124612.png (149.88 KiB) Viewed 950 times
backstrom1202
Posts: 8
Joined: Sat Apr 20, 2019 5:42 am

Re: Boosted 2013 Civic Si

Post by backstrom1202 »

Question for you did sent the boost controller to the b2 pin and the wideband to the a44 pin the ecu ?
Post Reply