First time datalogging

FlashPro questions & answers specific to the 2007-2012 Acura RDX
Post Reply
Apparation
Posts: 2
Joined: Fri Jul 13, 2018 8:17 am

First time datalogging

Post by Apparation » Fri Jul 13, 2018 8:19 am

Hey guys,

So here are two different datalogs of my 08 RDX with a CP-E intake and flashpro.

I flashed the ECU with the base (TUNED + K&N SRI) option. Did a few pulls and noticed some knocking with the knock retarding the timing alot.
I think its running lean, but why would hondata put out a base tune with these unsafe numbers??... please let me know what ya guys think.

The first datalog I was able to do a few WOT pulls
The second datalog was under light to medium load and it knocked even more.

Thanks!
Attachments
datalogjax91octkntuned2.zip
(1.34 MiB) Downloaded 34 times
datalogjax91octkntuned.zip
(1.39 MiB) Downloaded 34 times

User avatar
Hondata
Site Admin
Posts: 8762
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: First time datalogging

Post by Hondata » Wed Jul 18, 2018 8:14 am

The intake is causing the engine to run about 7% rich. AFM tuning will fix this.

The knock control and knock retard are normal. There is some variance between vehicles, and then with different fuel and a different intake you will not run identically to another vehicle.

You need to look at the datalog and identify where the knock control increases, and pull a little ignition timing out in those areas. This will overall increase power as the knock control will be lower.
Hondata

Post Reply