I cannot get the data logging sensors to read the 0-5v analog inputs.
I set it up correctly in the analog input tab and tested the voltage at the analog input header.
Any suggestions?
I have read multiple tech and wiring pages.
http://www.hondata.com/help/smanager/in ... meters.htm
No analog input values
Re: No analog input values
What is the serial number that is on the s300 board inside the ECU?
Post your calibration as well as a datalog showing the issue.
Post your calibration as well as a datalog showing the issue.
Re: No analog input values
Thanks for responding.
- Attachments
-
- Redbank to Northshore on stock map closed loop enabled.s3d
- (5.71 MiB) Downloaded 79 times
-
- Modified d16z6 9_15_19 3200L_6900RL.skl
- (47.05 KiB) Downloaded 83 times
Re: No analog input values
I can see values for them in the datalog. Make sure that you have a template set up that has the analog inputs setup to display and you should then see them in the graph window.
Re: No analog input values
I see it now on the sensors section, I must have something setup incorrectly on the display sections.
Re: No analog input values
You have selected the ECU analog inputs, and not the AN1 and AN2 analog inputs from the s300.