Moates obd1 engine sim v3 s300v3
-
- Posts: 5
- Joined: Mon Nov 28, 2022 11:23 am
Moates obd1 engine sim v3 s300v3
I have been trying to get the s300v3 to connect to datalogging in smanager. It connects but when i move load, rpm, tps etc. SManager shows its connected the ecu but none of the values change in the SManager. I can upload and download the calibration so i know the ecu is getting power. I have tested some other chipped obd1 ecus with a different rom editor with the engine sim so i know it work. Just have this issue with Smanager. Any ideas on how to get it to work?
Re: Moates obd1 engine sim v3 s300v3
Is J12 cut?
-
- Posts: 5
- Joined: Mon Nov 28, 2022 11:23 am
Re: Moates obd1 engine sim v3 s300v3
Yes j1 is cut.
Re: Moates obd1 engine sim v3 s300v3
I did not ask about J1.
-
- Posts: 5
- Joined: Mon Nov 28, 2022 11:23 am
Re: Moates obd1 engine sim v3 s300v3
my bad i forgot to hit the 2. j12 is cut
Re: Moates obd1 engine sim v3 s300v3
Make sure that the s300 is seated on the pins correctly.
-
- Posts: 5
- Joined: Mon Nov 28, 2022 11:23 am
Re: Moates obd1 engine sim v3 s300v3
it is seated down on the pins very snug
Re: Moates obd1 engine sim v3 s300v3
Does the ECU work in a vehicle?