i have a 2000 prelude with a jackson racing sc, intake, header, exhaust, msd 6al and blaster 2 coil, rc 550cc injectors. I just installed my new s300 (in p28 ecu). Before I started I did not have any error codes. After I got the s300 and injectors installed now I have error code 9 (cylinder sensor). I am running the h22 with jrsc and 550 cc inj cal. Is there some kind of setting that I have wrong. Can anyone help me. I have attached a copy of my cal
thanks Jacob
Problem with s300 and JRSC Prelude
-
- Posts: 10
- Joined: Mon May 01, 2006 6:53 am
Problem with s300 and JRSC Prelude
- Attachments
-
- h22supercharger550.skl
- (15.8 KiB) Downloaded 149 times
-
- Posts: 10
- Joined: Mon May 01, 2006 6:53 am
-
- Posts: 10
- Joined: Mon May 01, 2006 6:53 am
I swaped the two wires and nothing happened I still get the same error. I trouble shot the sensor and wiring harness and everything was ok. There is a yellow wire and a black wire do you know what pin each of them should be going to on the p28 I know where they are on my wiring harness. Just a question I am still using my obd2 dizzy and the injectors are for obd2 is all of that ok or did I need to swap all that to obd1
thanks
thanks
Last edited by ludechopper on Tue Sep 19, 2006 4:40 pm, edited 1 time in total.
-
- Posts: 10
- Joined: Mon May 01, 2006 6:53 am
The car will be in limp mode with that error. You will need to resolve this error before attempting to tune the vehicle.
Have any other aftermarket electronics been installed in this car?
We have had this reproted in a few isolated cases, and there never has been a concrete reason why 1 in 20 Preludes does this.
Have any other aftermarket electronics been installed in this car?
We have had this reproted in a few isolated cases, and there never has been a concrete reason why 1 in 20 Preludes does this.
-
- Posts: 10
- Joined: Mon May 01, 2006 6:53 am