B18C5supercharger 12 ohm 440 injectors

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Locked
User avatar
Spunkster
Site Admin
Posts: 22737
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

B18C5supercharger 12 ohm 440 injectors

Post by Spunkster »

B18C5supercharger 12 ohm 440 injectors
Attachments
B18C5supercharger 12 ohm.skl
(16.52 KiB) Downloaded 1589 times
Last edited by Spunkster on Wed Apr 29, 2009 12:41 pm, edited 2 times in total.
Jaker
Posts: 139
Joined: Thu Dec 05, 2002 12:37 pm
Location: Vancouver, BC
Contact:

Post by Jaker »

I am running this map in a freind's USDM B18C5 JRSC equipped car with RC 440 high impedance (12 ohm) injectors. The fuel trim in the calibration shows 510cc injectors. The car is ok at part throttle but extremely rich in boost and wide open throttle. Is it safe to assume that the fuel trim needs to be adjusted? Was this done to ensure the base calilbrations were "safe"?

Thanks

Jacques
User avatar
Spunkster
Site Admin
Posts: 22737
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

This is just how it displays based on the injector multiplier that was in the original bin. How rich at WOT is it?
tboostdsi
Posts: 80
Joined: Mon Mar 14, 2005 11:06 pm

Post by tboostdsi »

i have the same setup and i changed the fuel trim to 440 injectors and im running perfect a/f. 11.78 to 12.02 in boost WOT. Only problem it runs lean at like 15 vacuum(light throttle) in 5th gear cruising. i need to tune this part of the map. my setup is 9lbs jrsc b18c5 84mm bore. 9:4:1 compression ratio. try changing the injector to 440 and see what happens. every engine is going to be a little different.
Locked