calibrations for crower stage 2 3/4

patrick3531 · Post by **patrick3531** » Wed Oct 11, 2006 12:31 pm

I am getting the crower stage 2 3/4 cams installed in my car as we speak and I wanted to know if it is safe to use the calibration that is given in the Kmanager. It says crower stage 2 cams. Is there a calibration for the crower stage 2 3/4??? Thanks

Post by **Spunkster** » Wed Oct 11, 2006 2:54 pm

You can try using the existing calibration as a starting point for tuning.

patrick3531 · Post by **patrick3531** » Thu Oct 12, 2006 7:29 pm

I tried using the crower stage 2 calibration as a starting point, but it boggs out at 4900 rpm then continues on. I am going to Do it dyno performance center tomorrow. Hope everything goes well