I am about to chip a euro p28 (p28-G51) for hondata. When i opened it up, it does not have a air pressure sensor. Will this cause any problems?
no air pressure sensor in P28
JDM ecu's don't have it either
when you make a chip for your ecu you just need to disable the barometric presure sensor.
If you have ROM editor to program chips it's under the Options tab.
Or tell whoever makes the chip for you to disable it.
even with out it in the ecu and it not disabled the car should run fine
it may give you a error code though.
when you make a chip for your ecu you just need to disable the barometric presure sensor.
If you have ROM editor to program chips it's under the Options tab.
Or tell whoever makes the chip for you to disable it.
even with out it in the ecu and it not disabled the car should run fine
it may give you a error code though.
-
- Posts: 351
- Joined: Fri Aug 16, 2002 10:45 pm
- Location: PHILIPPINES
- Contact:
-
- Posts: 3
- Joined: Sat Jan 17, 2004 1:38 pm