I just purchased a s200 system that has boost and data logging, however the seller did not send me the data logging cable to connect to my laptop. Can I use any serial cable or did I need a special cable from hondata?
Also I know we arent suppose to post about this but I did email support with my serial number (s200-0232) asking what options it has and also asked if it has the 3 Step feature. They answered but only to tell me it has boost and data logging, did not say whether or not it has 3 Step. Could someone check on that for me.
Thanks
Kevin
s200 data logging
-
- Posts: 14
- Joined: Fri Jul 25, 2008 4:21 pm
s200 data logging
Surgeon General's Warning:
It IS OK to smoke V8's
It IS OK to smoke V8's
-
- Posts: 14
- Joined: Fri Jul 25, 2008 4:21 pm
-
- Posts: 14
- Joined: Fri Jul 25, 2008 4:21 pm
-
- Posts: 14
- Joined: Fri Jul 25, 2008 4:21 pm
ok so I got my odb2 to odb1 conversion harness in today and went to install my s200. Once everything was hooked up the car starts and runs but I get a slow blinking LED on the interface box (stays on in between blinks). I have a D9 to USB cable to connect to my laptop. I cant seem to get Hondalogger to connect to the ECU. It just says connecting forever. Am I using the wrong cable to connect to the ECU through Hondalogger?
Surgeon General's Warning:
It IS OK to smoke V8's
It IS OK to smoke V8's
-
- Posts: 8
- Joined: Sat Dec 15, 2007 1:44 pm
- Location: yeovil/kingston drives 106 and civic
- Contact:
i am in the same situation as this, using a obd2-obd1 converter and then when i connect the chipped p28 and hondata unit to the car, it will start and run but i have a constant cel light and the hondata unit blinks but doesnt seem to relate to a code :(315Customs wrote:ok so I got my odb2 to odb1 conversion harness in today and went to install my s200. Once everything was hooked up the car starts and runs but I get a slow blinking LED on the interface box (stays on in between blinks). I have a D9 to USB cable to connect to my laptop. I cant seem to get Hondalogger to connect to the ECU. It just says connecting forever. Am I using the wrong cable to connect to the ECU through Hondalogger?
same with connecting it to a laptop
no one can hear you scream at 9000rpm!! www.nath106.co.uk