I know theres lot of threads already, but none of them seem to be able to help.
I just recently got the boost control hardware installed onto my s300 ( by a hondata dealer ). Brought it home and connected the solenoid as shown in the tech diagrams. Went into the s300 and enabled boost control through a11. When turned the ignition on, i dont hear a click for the solenoid. So i checked the wiring. The thing is on my 0bd2a-obd1 conversion harness there was already a pin on a11. I connected my multimeter to check for a ground output from a11 which ignition turned on, and im not getting anything.
Would this be a fault in the installation of the boost control hardware or
is there something that im missing?
S300 with boost control option: not working
-
- Posts: 39
- Joined: Sat Jun 14, 2008 9:45 am
- Location: tx