A/f gauge problem
A/f gauge problem
Does anyone know if the A/F gauge problem has been fixed yet in the latest version of Smanager?
I get the message "Floating point division by zero" everytime i try to open a A/F ratio gauge in the Display part of Smanager. It keeps popping up non-stop to a point where i have to close it or else it'll freeze my laptop. i have the latest version of Smanager. I'm running Vista. I try to delete the current display files but that doesnt do anything. I even try to get some of the demos that i downloaded here with the A/F gauge and those files open but wont work. is this just a windows vista thing?Spunkster wrote:There are no known issues with the A/F guague display.
alrite. got it to work. another hooray for hondata! works awesome.Hondata wrote:In Smanager under Settings try both lambda unit options (air/fuel and lambda).
If you have a calibration loaded then under Closed Loop check the voltage/lambda conversion - none of the air/fuel or lambda numbers on the bottom line should be zero.
-
- Posts: 15
- Joined: Thu Oct 09, 2008 2:57 am
I too have the same problem.
I have done as instructed above with no difference.
I've had to re-install SManager twice now. This is the third time it has happened in the matter of hours.
This time it has deleted all my display files too. When I click on "display" I get the error as mentioned above, I click "OK"...I then click on "display" once again to get an error of "can not open file...default.display".
I have done as instructed above with no difference.
I've had to re-install SManager twice now. This is the third time it has happened in the matter of hours.
This time it has deleted all my display files too. When I click on "display" I get the error as mentioned above, I click "OK"...I then click on "display" once again to get an error of "can not open file...default.display".