S300 calibration for JUN III cams

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Locked
B16B
Posts: 12
Joined: Sat Jun 03, 2006 2:30 pm
Location: New Zealand

S300 calibration for JUN III cams

Post by B16B »

Hello all,

Engine spec:
Standard B16B bottom end.
Standard ITR head with flat face valves.
Standard 62mm ITR throttle body
370cc RC Injectors
JUN III cams

We are having problems tuning out the whole that has appeared when it changes from Low to High cam

Tried:
Moving v-tec change point
Changing back to 60mm CTR throttle body

Can anyone assist or even supply a calibration that may help?

Thanks
Brent
OTT
Posts: 62
Joined: Wed Sep 15, 2004 7:48 am
Location: Yorkshire, England
Contact:

Post by OTT »

You got this in an EK9 then?

what wideband are you useing?

I'm sure I can help
B16B
Posts: 12
Joined: Sat Jun 03, 2006 2:30 pm
Location: New Zealand

Post by B16B »

OTT wrote:You got this in an EK9 then?

what wideband are you useing?

I'm sure I can help
No, its an EG4 with EK9 running gear basically.

Not sure what you mean by wideband, do you mean oxy sensor?

The guy that does my tuning suggested I post something on here to try & find some help.

Any help is appreciated.

thanks
Brent
OTT
Posts: 62
Joined: Wed Sep 15, 2004 7:48 am
Location: Yorkshire, England
Contact:

Post by OTT »

have you got an email?
B16B
Posts: 12
Joined: Sat Jun 03, 2006 2:30 pm
Location: New Zealand

Post by B16B »

Just sent you an e-mail from your website.
cranny
Posts: 488
Joined: Sat Feb 23, 2008 9:58 pm

Post by cranny »

do you have any datalogs of this?
vteczone
Posts: 11
Joined: Mon Sep 10, 2007 9:36 pm

Re: S300 calibration for JUN III cams

Post by vteczone »

B16B wrote:Hello all,

Engine spec:
Standard B16B bottom end.
Standard ITR head with flat face valves.
Standard 62mm ITR throttle body
370cc RC Injectors
JUN III cams
how did u go with the tune for the above set up? could u post the map for it?
Locked