hello, I 'd like to know if hondata's d17 kpro flash will fit on the european d16v1 (civic 2005, looks like an SI)... the engine almost the same as a d17a2 (em2)
ecu partnumber: 37820-PMH-G02
engine:
d16v1:
d17a2
hope someone can help me... there isn't much difference in ecu pinout.. but cannot find any draw from a d16v1..
grtz
Rigo
Hondata on d16v1
I understand ;)
can you tell me which ecu wires I must have 100% ? maybe I can do some fitting work on d16 connector to have the same signals as d17.. ( I miss some cables though, like an acc wire etc, not much important) but it would be nice if I had a schematic from hondata where alle in- and outputs are shown.. just to see which ones I really need, to make the kpro fit on the d16v1..
I'm sure a lot of people would be happy with it ;)
grtz
Rigo
can you tell me which ecu wires I must have 100% ? maybe I can do some fitting work on d16 connector to have the same signals as d17.. ( I miss some cables though, like an acc wire etc, not much important) but it would be nice if I had a schematic from hondata where alle in- and outputs are shown.. just to see which ones I really need, to make the kpro fit on the d16v1..
I'm sure a lot of people would be happy with it ;)
grtz
Rigo
Re: Hondata on d16v1
Any result or progress? Also looking for something for D16V1