ROM Editor 4 tuning software questions and answers.
10 posts • Page 1 of 1
Hi, I got my RE4 and bought a used s200 to replace my old faulty one. when start tuning the highlighted area on colums(fuel/ign map) doesnt work while the car running. do i have problem with datalogging even though i have unlocked the codes for datalogging on the used s200?
Hi, the light is flashing with my p27 ecu but not in my p72. yes i did burn a chip with the p72 for a test, it is responding except for datalogging.Spunkster wrote:HAve you actually burned a chip yet? IF the light is flashign then there is no communication between the chip and the s200, so you have either a blank chip, bad bin file in the chip, or a bad ecu socketing job.
Please see page 12 in the s100/s200 user guide: http://www.hondata.com/downloads/S200%2 ... 0Guide.doc
My main problem is not having the datalogging to work on my p72. i dont have this problem with the romeditor3 before. but since i upgraded to RE4 and using a replacement s200 i bought from a friend (working fine) i suddenly had problems.. the highlighted colums on the fuel and ign map does'nt work. its really hard to tune without it..Spunkster wrote:Please see page 12 in the s100/s200 user guide: http://www.hondata.com/downloads/S200%2 ... 0Guide.doc