FlashPro on FN2 Cruise Control problem
FlashPro on FN2 Cruise Control problem
I have a problem with cruise control on 6th gear, it doesn't work. I tried Group N reflash and "MAP based, race header, highflow cat, stock catback." for FN2 calibrations. It works on 5th gear fine, but on 6th it works only when rpm's are at 2k-3k.
Yes, Type-R GT. ECU code number: RSP-E03.Spunkster wrote:Do you have a Type R GT? What is the ECU code number?
With MAF Groupe N reflash cruise control doesn't work at all.
With MAP raceheader tuned, when I mark "Cruise control enabled" in "Misc" it works, but not on 6th gear.
On which calibration I should datalog?
I've made two datalogs with "Group N Reflash" and "MAP based, race header, highflow cat, stock catback" calibrations.
Could you advice which calibration is better to use with bolts on like header, catback, hondata heat gasket? It seems that MAP based runs better...
Could you advice which calibration is better to use with bolts on like header, catback, hondata heat gasket? It seems that MAP based runs better...
- Attachments
-
- datalogs.rar
- gpn.fpdl - Group N Reflash calibration datalog
map.fpdl - MAP based, race header, highflow cat, stock catback datalog - (164.59 KiB) Downloaded 430 times
same problem. :(walter wrote:Yes, Type-R GT. ECU code number: RSP-E03.Spunkster wrote:Do you have a Type R GT? What is the ECU code number?
With MAF Groupe N reflash cruise control doesn't work at all.
With MAP raceheader tuned, when I mark "Cruise control enabled" in "Misc" it works, but not on 6th gear.
On which calibration I should datalog?
-
- Posts: 1
- Joined: Tue Jul 07, 2009 12:16 pm
- Location: St.-Petersburg, Russia