FN2 FLASHPRO BUG IN BETA NEWEST VERSION
FN2 FLASHPRO BUG IN BETA NEWEST VERSION
Hi Hondata,
I have uploaded a cal (Nuno´s one), so I checked for the last update and refresh both hondata software and hondata flashpro firmware (with beta version).
After uploading a cal, I tried to datalog to have a look at the parameters in the laptop and when I push the datalog button, the cars attempts to stop but finally it doesn´t stop (due to a low oil pressure, which is indicated in the dashboard). I tried this using laptop and using only the flashpro unit, pressing the datalog button, but again the same problem.
I restarted the laptop, and the problem continues, so I can´t see the datalog of the car. I uploaded the cal and the car runs good but I can´t see the datalog (live datalog).
Hope you can fix this, or advice me.
Regards,
BOSS
I have uploaded a cal (Nuno´s one), so I checked for the last update and refresh both hondata software and hondata flashpro firmware (with beta version).
After uploading a cal, I tried to datalog to have a look at the parameters in the laptop and when I push the datalog button, the cars attempts to stop but finally it doesn´t stop (due to a low oil pressure, which is indicated in the dashboard). I tried this using laptop and using only the flashpro unit, pressing the datalog button, but again the same problem.
I restarted the laptop, and the problem continues, so I can´t see the datalog of the car. I uploaded the cal and the car runs good but I can´t see the datalog (live datalog).
Hope you can fix this, or advice me.
Regards,
BOSS
I pressed the start/stop datalogging button on the laptop (ray icon) and did what I explained before, and also disconnected laptop and used only hondata flashpro, pressed "datalog button" and did the same.Spunkster wrote:The datalog buttonon the FlashPro does not start the datalogging on the laptop. You must push the datalogging button or F10 on the laptop to see the realtime datalogging on the laptop.
Hope I have explained this better than before.
Thanks for your response Nuno. I didn´t have a couple of minutes to do what Spunkster said, but It feels strange that I can´t directly datalog... and I have done this datalogs (live datalogs) a lot of times.
I would be please if Hondata could investigate and solve this, because even Nuno writes it is a common bug in the beta software.
Thanks in advance.
I would be please if Hondata could investigate and solve this, because even Nuno writes it is a common bug in the beta software.
Thanks in advance.
this is what was reported by a friend:
"Everything went good upload the cal to ECU but when I push Datalog button to record the car goes nuts like click click click and message VSA and check engine etc etc comes up in display and engine shut down. I turn off with key and turn on again, car start normal again, but I cant push Datalog button..."
"Everything went good upload the cal to ECU but when I push Datalog button to record the car goes nuts like click click click and message VSA and check engine etc etc comes up in display and engine shut down. I turn off with key and turn on again, car start normal again, but I cant push Datalog button..."