Rev Hang for Asia CR-Z

FlashPro questions & answers specific to the 2010 CR-Z (US, Euro & Asia)
Post Reply
lvxnid
Posts: 4
Joined: Wed May 15, 2013 7:17 am

Rev Hang for Asia CR-Z

Post by lvxnid » Wed May 15, 2013 7:31 am

Hi, I am trying to eliminate rev hang on my CR-Z by reducing the "Overrun fuel cut delay" but when I tried uploading the calibration there is an error code "P2467 - VTEC Oil Pressure Switch Circuit High Voltage" and my dash panel gives me "CHECK EMISSION SYSTEM" message until I revert it back to stock ECU setting.

Question is:
- Am I doing correctly t oeliminate rev hang by reducing the "Overrun fuel cut delay"?
- Is there any parameter to change in order to eliminate rev hang on CR-Z?
- What needs to be done to correct the error code P2467?

Thank you Guys!

User avatar
Hondata
Site Admin
Posts: 8751
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Rev Hang for Asia CR-Z

Post by Hondata » Wed May 15, 2013 8:15 am

What ECU do you have, and what calibration are you using?
Hondata

lvxnid
Posts: 4
Joined: Wed May 15, 2013 7:17 am

Re: Rev Hang for Asia CR-Z

Post by lvxnid » Thu May 16, 2013 3:16 am

Thank you for your response. I am using stock ECU and uploading Flashpro "CRZ-Asia-1" base calibration.

User avatar
Hondata
Site Admin
Posts: 8751
Joined: Thu Aug 15, 2002 12:13 pm
Location: Torrance, CA
Contact:

Re: Rev Hang for Asia CR-Z

Post by Hondata » Thu May 16, 2013 7:59 am

The fuel overrun cutoff delay values are 60ms - you can try reducing these to see if it makes the rev hang better.

Does your vehicle have a VTEC oil pressure switch? If not, disable the test under VTEC / Options.
Hondata

lvxnid
Posts: 4
Joined: Wed May 15, 2013 7:17 am

Re: Rev Hang for Asia CR-Z

Post by lvxnid » Thu May 16, 2013 8:25 am

I'll check whether there is VTEC oil pressure switch on my model. Is this not a standard for VTEC engine?

I tried reducing the Overrun fuel cut delay until 10 ms and I got rev hang almost eliminated. Will this value be bad to the engine?

User avatar
Spunkster
Site Admin
Posts: 17931
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata
Contact:

Re: Rev Hang for Asia CR-Z

Post by Spunkster » Thu May 16, 2013 11:14 am

Not all engines have VTEC oil pressure.

This will not hurt anything, it just makes it more drivable.

Post Reply