Car is a 2004 CRV 5 speed. Engine is a 2004 TSX. I will retain the stock 5-speed from the CRV.
I assume I can just use the TSX long block and bolt on my CRV accessories (power steering, alt, a/c) and use the CRV engine harness. Anything different about the intake manifolds that might be a concern?
For ECU, I am wondering if I can get Kpro installed in my factory 2004 CRV manual edu OR can I just use the TSX ecu (are the plugs exactly the same?)
Thanks for any info.
2004 TSX K24 into my 2004 CRV
Re: 2004 TSX K24 into my 2004 CRV
What is the part number on the CRV ECU?
Re: 2004 TSX K24 into my 2004 CRV
37820-PNL-E02
Re: 2004 TSX K24 into my 2004 CRV
I'm sorry, but we do not have anything that will work with that ECU.
Re: 2004 TSX K24 into my 2004 CRV
I'm wondering if I can just use the 2004 TSX manual ECU in my CRV. I know that the TSX ecu will look for throttle by wire so I will have to get the accelerator position sensor from the TSX.
Will the cabin harness from the CRV plug right into the TSX ecu, so that my gauge cluster works appropriately?
Will the cabin harness from the CRV plug right into the TSX ecu, so that my gauge cluster works appropriately?
Re: 2004 TSX K24 into my 2004 CRV
I do not believe any of these will work in combination with one another.
Re: 2004 TSX K24 into my 2004 CRV
So can I buy an ECU that is K Pro compatible and get a tune for a stock TSX motor?
Re: 2004 TSX K24 into my 2004 CRV
The TSX ECU cannot be used, and you cannot use the stock ECU with drive by wire.
Post a picture of the inside of the stock ECU.
Post a picture of the inside of the stock ECU.
Re: 2004 TSX K24 into my 2004 CRV
Cr-v RD8+K24A2turbo+Kpro V4 prb+NPR3/6Speed+ТС+ HFS4 v3.2.
DynoWheel = 472kW / 589 N.m
HRX One Mile Challenge = Max Speed 282km
Known as Sniper
DynoWheel = 472kW / 589 N.m
HRX One Mile Challenge = Max Speed 282km
Known as Sniper